Hurst - Hurst Roll/Control, Line/Loc Kit - Ford Mustang

Hurst - Hurst Roll/Control, Line/Loc Kit - Ford MustangThe Hurst Roll Control, Line Loc kit for your 2011 2014 Ford Mustang is primarily used in drag racing to lock the front wheels allowing for more consistent burnouts when heating up the tires to make a pass. This kit comes with all the necessary parts needed to easily install a Hurst Line Loc system on your Mustang. Includes a stainless steel Roll Control valve, brake line, fittings, lighted momentary switch, bracket, wiring and much more. Rigorous

Cylinder Head Stud Kit - Hex / 12 Point Nuts - Chromoly - Black Oxide - Cadillac V8 - Kit

Engine Lift Plate - 3/16 in Thick - Steel - Cadmium - Gen III - GM LS-Series Valley Cover Flange - Each

685 in Knurl - Steel - Black Oxide - Mopar - Set of 5

Timing Pointer - Stainless Hardware - Aluminum - Black Anodized - 6-3/4 in OD Balancer - Small Block Chevy - Each

T-Shirt - Allstar Logo - Red - 2X-Large - Each

Finally an answer for your AMC's worn out breaker points distributor

Nose - Outlaw - Driver Side - Plastic - Fluorescent Orange - Universal - Asphalt Late Model - Each

Headset Cable - Listen Only - 90 Degree - 1/8 in Male to 1/8 in Female Jack - Spiral Cord - Each

19 in Extended - 1

150 Orifice - Stainless - Holley / Quick Fuel Carburetors - Alcohol - Each

63 in Tall - 1-16 in Thread - Steel - Orange Paint - Ford Powerstroke - Each

The best crimping tool available for making custom wire sets or wiring