XDP Thread Cleaning Chaser (M12x1.75) XD40125TC

XDP Thread Cleaning Chaser (M12x1.75) XD40125TCPrepare your engine block for re assembly with the XDP Thread Cleaning Chaser (M12x1. 75) XD40125TC. This is a must have for anyone working on their engine. Cleaning threaded holes is crucial whether you're installing aftermarket head studs, main studs, factory style bolts, or any other fasteners. The purpose of a thread chaser is to clean the internally threaded holes in your engine block. To use a thread chaser is simple, you just run the tool

Core Height: 35-3/4 inch

100 percent End-Of-Line Tested Through Complete RPM Range

The threads are rolled after heat-treating to provide maximum fatigue strength

The XDP Bellowed Up-Pipes eliminate the troublesome donut gaskets and replace them with a durable steel crush gasket that will not blow out or leak over time

The flange on the bolts distributes pressure where the fastener meets the surface

Complete Set (Springs

checks are performed for microscopic damage at the housing

In addition

0L Powerstroke

Required installation tool not included

and the plastic mix includes a fiber reinforcement that is added during tank construction

This set comes ready to install with military style battery terminals