RPM Front or Rear A-arms for Traxxas Slash/Stampede 4x4 (Red) (2) Silver Horse RC

RPM Front or Rear A-arms for Traxxas Slash/Stampede 4x4 (Red) (2) Silver Horse RCThis is an optional RPM Traxxas 4x4 A Arm Set. These arms can be used in the front or rear position of the Traxxas Rally, Slash 4x4 and Stampede 4x4 vehicles. RPM A arms for the Slash 4x4 and Stampede 4x4 eliminate the slop in the suspension system, tightening the tolerances around the hinge pins. Plus, they reduce the fore and aft movement of the A arms at both the inner hinge pin and at the axle carriers by better than 90% and improve the durability

Shaft Diameter x Length: 3

Designed specifically for the UpGrade RC 1

(1) MM-200 Brushed Motor

dropping the ride height for a lower center of gravity

if all that speed leads to getting capsized after too tight of a turn

3D prints ARE NOT dishwasher safe and should be hand washed only

High-Torque 347 Digital Metal Gear Servo

Servo case/gaskets (for 2085 & 2085X servos)

Vehicle Fitment:

and cleaning sponge

Sold individually

With two JST-XH balance boards thrown in for free - one for each channel - you'll be ready to go right away