34mm Split Clamp for jockey wheel / prop stand TR024 Parts Organisers

34mm Split Clamp for jockey wheel / prop stand TR024 Parts OrganisersThis listing is for a 34mm pressed steel clamp for trailer jockey wheels and prop stands. 34mm diameter. High quality, OEM standard. Split clamp design makes it easy to remove the jockey wheel if required. Steel construction, fully galvanised. The mounting holes are 10mm and are at 105mm centres.

High quality drill set for commercial or occasional use

Bradley arguably make the best trailer accessories and components on the market and are fitted by many top manufacturers

Listing is for one pair (one red (+) one black ()

Size of the float 350mm x 130mm

Will fit trailers with the standard 50mm tow ball coupling

motor boats

down spouts vents

If it is not then you should note which pin number each wire goes to before removing the old socket and simply connect the new one the same

Ground centre point with carbide tips for added strength and longer lasting of the drills

Tough outside insulation provides good protection against rubbing and chafing

1-1/4" Size to fit 1-1/2" (38mm) diameter hole in base of sink

Metric sized ring spanner set