Sterling By Musicman SB14 (2010) - Brushed Gold hardware-strap-buttons

Sterling By Musicman SB14 (2010) - Brushed Gold hardware-strap-buttonsThis replacement pickguard is made specifically for the Sterling by Musicman SB14 model, cut with one Humbucker in the bridge position. The pickguard template was taken from an authentic 2010 model Musicman SB14 Sterling Bass model. Made from black plastic with a very thin layer of simulated brushed gold on top. 2. 28mm thick (. 090") with a 45 degree outer bevelled edge. Close up side view profile:

Lightly reliced with yellow discolouration and various marks and scuffs

Please note that this pickguard will only fit the 60th Anniversary Precision Bass and will not fit any other Precision Bass variant

jack socket and 6 bridge through-body-string holes

Made from 3 ply white/black/white material and comes with a 45 degree bevelled edge and a clear protective film to prevent it from being scratch during installation

This design requires an individual mounting hole location offset at approximately 7 O'clock or 4 O'clock depending on left or right handed application (bass or treble side)

Made from a single ply off-white parchment material measuring 1

The original Kluson tuning machines are based on a 12:1 gear ratio

Will fit split shaft pots

With meticulous attention to detail and an unwavering commitment to quality

Priced and sold as a set of three saddles

28mm thick with a black middle layer

VS100N Tremolo System